IHome IP21 User Manual download pdf (Page 6)

Installing Backup Battery

iP21 Display

Install Clock Backup Battery

PM Indicator

Battery Low Indicator

Daylight Saving Time

Indicator

iPhone/iPod Indicator

Sleep / NAP Indicator

Alarm Indicator

Time Display

The iP21 uses a CR2032 button cell backup battery system to provide

continuous alarm operation and clock settings in the event of a power

failure. The CR2032 battery comes installed in the unit. Simply pull the tab to

initiate contact. If a power failure occurs or the AC adaptor is accidentally

disconnected,the display backlight will not remain lit, but current time and alarm

time settings will be temporarily maintained. Otherwise, you must reset the time

and alarm settings. When the Battery Low indiator blinks on the display, the

battery should be replaced.

1. Please make sure the AC adaptor is connected. Otherwise all settings may

be lost during battery installation/replacement.

2. Using a Phillips screwdriver, open the battery compartment door located on

the bottom of the unit.

3. Remove the old battery and insert one CR2032 button cell battery, checking

that the + side is facing upwards. Replace the compartment door.

Note: Make sure you dispose of batteries properly (see your local regulations).





1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

IHome IP21 User Manual Page 6